Slinging.org Forum - Apache sling

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Apache sling Dec 31^st, 2024 at 5:43am I made an Apache sling yesterday and took some pictures along the way. I wanted a sling as long as my arm when loaded, so I took a roll of jute twine and cut three pieces, each piece was six times longer than my arm plus a bit more just to be sure. I found the centre of each length and laid them out.
Back to top	PXL_20241230_105917706.jpg (166 KB \| 16 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #1 - Dec 31^st, 2024 at 5:44am I brought the three strands together at the centres and tied a knot.
Back to top	PXL_20241230_110047652.jpg (176 KB \| 8 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #2 - Dec 31^st, 2024 at 5:45am Then I started braiding the fingerloop
Back to top	PXL_20241230_110249021.jpg (247 KB \| 9 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #3 - Dec 31^st, 2024 at 5:47am Once I had enough braid to make the loop I untied the knot and brought the ends together, pairing each cord with its opposite partner.
Back to top	PXL_20241230_110626542.jpg (176 KB \| 11 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #4 - Dec 31^st, 2024 at 5:49am Next I braided the paired cords. I use a wrapping motion for this, so that the upper side of a pair of cords ends up facing down as it crosses the centre pair.
Back to top	PXL_20241230_110816467.jpg (223 KB \| 9 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #5 - Dec 31^st, 2024 at 5:51am After a good bit of braiding I had enough for my release cord, measured against my arm minus a little bit for the pouch.
Back to top	PXL_20241230_112036062.jpg (169 KB \| 9 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #6 - Dec 31^st, 2024 at 5:52am Then I redistributed the strands so I had two three's
Back to top	PXL_20241230_112242893.jpg (157 KB \| 11 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #7 - Dec 31^st, 2024 at 5:54am Then I braided the sides of the pouch. The right length for a pouch is when it wraps around the ammo you want to use.
Back to top	PXL_20241230_114646599.jpg (227 KB \| 9 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #8 - Dec 31^st, 2024 at 5:56am Now bring the two pouch sides together and pair up their strands. These have to be exactly the same length and exactly the same tension.
Back to top	PXL_20241230_115037202.jpg (187 KB \| 9 ) IP Logged

David Morningstar

Slinging.org Moderator

Offline

Slinging Rocks!

Posts: 3481
UK

Re: Apache sling
Reply #9 - Dec 31^st, 2024 at 6:00am

Now start braiding to join the two pouch sides together. Check the tension of each side, undo and try again if one is tighter than the other. I had to do this twice to get it right.
You can just braid out to the end of the release cord with three pairs, but I like to do something a little fancy. I choose two strands and cut them short.

Back to top

PXL_20241230_115643493.jpg (174 KB | 19 )

IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #10 - Dec 31^st, 2024 at 6:02am Then I did something I should have done earlier, I attached the fingerloop to a coathook and was able to pull tight as I braided.
Back to top	PXL_20241230_120120471.jpg (201 KB \| 9 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #11 - Dec 31^st, 2024 at 6:03am This makes braiding much easier and I should have dome this as soon as I had a fingerloop
Back to top	PXL_20241230_120157470.jpg (74 KB \| 9 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #12 - Dec 31^st, 2024 at 6:06am Now I was able to change braids to a four strand round braid, sometimes called a square braid. I kept the two short strands in the centre, not including them in the braid. They ended up buried in the centre of the braid so you dont see the ends and they cannot start coming loose.
Back to top	PXL_20241230_120711133.jpg (111 KB \| 10 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #13 - Dec 31^st, 2024 at 6:08am Once the short cords are hidden it is just a square braid all the way to the finish. I like the square braid because it is very flexible and it allows me to drop strands to make a lighter release cord without any exposed ends.
Back to top	PXL_20241230_121027173.jpg (133 KB \| 8 ) IP Logged

David Morningstar Slinging.org Moderator Offline Slinging Rocks! Posts: 3481 UK	Re: Apache sling Reply #14 - Dec 31^st, 2024 at 6:09am Measuring the release cord to make sure it is braided to exactly the right length Click here for page 2 ---> https://slinging.org/forum/YaBB.pl?num=1735641784/15
Back to top	PXL_20241230_125301050.jpg (148 KB \| 17 ) IP Logged