Slinging.org Forum
https://slinging.org/forum/YaBB.pl
General >> Other Primitive Weapons >> Made a Throwing knife from Hex key/Allen key
https://slinging.org/forum/YaBB.pl?num=1523831411

Message started by timpa on Apr 15th, 2018 at 6:30pm

Title: Made a Throwing knife from Hex key/Allen key
Post by timpa on Apr 15th, 2018 at 6:30pm
I'm tinkering again :)

https://www.youtube.com/watch?v=H-JLuZP-gDU

Title: Re: Made a Throwing knife from Hex key/Allen key
Post by kicktheotter on Apr 15th, 2018 at 10:40pm
Awesome work once again Timpa :D

Title: Re: Made a Throwing knife from Hex key/Allen key
Post by timpa on Apr 16th, 2018 at 6:58pm
Kiitän :)

Title: Re: Made a Throwing knife from Hex key/Allen key
Post by Bill Skinner on Apr 23rd, 2018 at 12:06pm
Those actually look rather good.  In a ninja sort of way.   ;D

Why did you cut the key off at the bend?  If you could heat it up to red hot, it should hammer straight.

Is the weather still bad where you are?  I've noticed that when the weather is bad and you pretty much have to stay in your shop, you tend to get creative.

Looking forward to your next video.   :)

Title: Re: Made a Throwing knife from Hex key/Allen key
Post by timpa on May 19th, 2018 at 8:43pm
The straight part was long enough. That's why I cut it off.

:)Thanks for asking; Here's the good weather right now. All kinds of things I plan. :D

Title: Re: Made a Throwing knife from Hex key/Allen key
Post by Frondeur on May 21st, 2018 at 7:13am
Awesome!

Just one question: did you temper your blade after forging? or after finitions?

thanks angain for stimulating our imaginations.

Title: Re: Made a Throwing knife from Hex key/Allen key
Post by timpa on May 30th, 2018 at 7:21pm
It has not been hardened / tempering. It's only forged.

Slinging.org Forum » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2024. All Rights Reserved.